There could be so many Linksys velop setups in the market, but you will be shocked to know that the setup of all is the same. However, sometimes the velop can take a lot of ways to set up the device but will tell you only one or two out of them. 

Just connect the wireless range velop to a power extension using a power cable, and wait for the LED light to turn optimally. Attach an ethernet wire with the velop on the back panel of that and wait for the light to turn ideally. But it depends on the different models, in some models it is green the strong indicator while in some blue.

Connect the device like the computer or the mobile, etc. to the default SSID of the Linksys velop setup. Just feed the web address of the velop which might be present in the back of the velop panel. The web address will easily redirect you to the web interface of the velop. From there you can do the velop setup quickly. For more details check the velop setup manual guide or follow the device screen directions, if this is not helpful then you need to use the Linksys velop setup app.